![]() While some computers will successfully boot all modes, some may only boot several or one. Select the desired USB Layout for the UFD (layouts available for selection will vary depending on the boot media being created).Note: If your UFD is a U3 device, please read the special notes below. Highlight the target device in the list.It should be identified by the make/model of the device (e.g. When you get to the point where you select the target, the UFD device will appear under the USB/SD category. In either case, MakeDisk will provide several confirmation messages prior to overwriting the device/partition.Ĭreating the UFD Installation/Boot Disk: Run MakeDisk and follow the prompts in the normal manner. Important: When you use MakeDisk to create or update the installation/boot media on a UFD device, all existing data on the device will be lost unless one of the Multi-Partition layouts was used and MakeDisk gives the option to only update the boot media partition. You can allow MakeDisk to support larger devices by clicking the USB+ button on the Select Target step or by specifying the /nousblimit parameter when it's run (e.g. For that reason, devices larger than 64 GB will not appear in MakeDisk. MakeDisk is not included with CopyWipe, but can be downloaded. By default, for data safety reasons, MakeDisk does not support UFD devices that are larger than 64 GB in size. MakeDisk is included with the current versions of the above TeraByte products. This capability applies to the following products: ![]() ![]() The MakeDisk utility offers the option to create the installation/boot media on a USB flash drive (UFD). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |